Click here to view the Hydra Quickstart guide, featuring detailed instructions on how to program the Entone remote by code, and other general information. Or follow the instructions below to program the remote using the auto function.

1. Power on the device and on the remote control, press the desired device key once.
2. Press and hold “SETUP” until the device key blinks twice, then release “SETUP”.
3. Press the “POWER” key once and aim your new remote at the device.
4. Press either the “CHANNEL UP” key or “CHANNEL DOWN” key to do device auto-scan.
5. In this search mode, the remote control will send IR codes from the library in 5 second intervals. The device key will be on and blink every 5 seconds while in the device scan mode.
6. If the device turns off, a working code has been found. Press “OK” once to lock in the code. The selected mode key will blink twice.
7. If all code sets of that device are exhausted in the search and the “OK” is not pressed, the selected device key will fast blink 7 times and the search mode will be terminated.
   

NOTE: If the TV does not turn on during step 6, then slowly press and release CH- to go back through the codes, then press RCU SETUP when the TV turns on.

ADB remote

Click here to view the ADB Remote guide, featuring detailed instructions on how to program the ADB remote by code, and other general information. Or follow the instructions below to program the remote using the auto function.

1. Turn on your TV.
2. On the remote control, press TV once; it will blink once.
3. Press and hold RCU SETUP until the TV key blinks twice.
4. Type 9 9 1. The TV key will blink twice.
5. Aim the remote control at the TV and press POWER once.
6. Press and release the CH+ key continuously, then stop when the TV turns off.
7. Press POWER. The TV should turn on, then press RCU SETUP once to lock in the code. The LED will blink twice to indicate that the code is saved.

To search for the codes of your other devices, repeat steps 1 through 6, but substitute the appropriate key (e.g., VCR, DVD, AUD, or STB) for the device you are searching for.

NOTE: If the TV does not turn on during step 6, then slowly press and release CH- to go back through the codes, then press RCU SETUP when the TV turns on.

Please refer to the Kalona HDTV Remote/DVR Users Guide (PDF)

Please refer to the Kalona HDTV Troubleshooting Guide (PDF)